Characterization and actuation behavior of SPS/SGO ion exchange polymer actuator based on PEDOT: PSS/SGO composite electrode

ABSTRACT

This paper studied the fabrication of new hybrid-type poly(3,4- ethylene dioxythiophene) (PEDOT)/sulfonated graphene oxide electrode-based polymer actuator produced by film casting method. Sulfonated Poly(1,4-phenylene ether-ether sulfone) (SPS) ion-exchange polymer membrane-based ionic polymer composite actuators were fabricated using the different concentration of SGO. The characterization and actuation were demonstrated. By altering SGO concentration, four different SPS based membrane actuators were analyzed. The effects of SGO concentration on the morphology, proton conductivity, ion exchange capacity, and water uptake capability were studied. The maximum tip displacement and force by varying concentration of SGO were evaluated for the actuation performance.     

乙丙嵌段共聚物相对分子质量及链结构对PP/EPR共混体系结构与性能的影响

设计合成了一系列不同相对分子质量和乙烯平均序列长度的乙丙嵌段共聚物（EP），并将其作为聚丙烯（PP）/二元乙丙橡胶（EPR）共混体系的增容剂，考察了EP用量、相对分子质量及乙烯平均序列长度对共混体系性能及分散相形态演变的影响。结果表明，EP增容PP/EPR体系时存在最佳添加量，少量EP的加入可有效提高PP/EPR共混体系的抗冲击性能，并对分散相尺寸及形态起到良好的调控作用；同时，EP的相对分子质量越大对共混体系的冲击性能提高越明显，EP的组成与EPR越接近，对共混体系的增容效果越明显。     

电解锰渣制备微晶玻璃正交实验研究

将煅烧后的电解锰渣作为单一的实验原料,采用烧结法,制备微晶玻璃,通过正交实验对锰渣微晶玻璃的热处理方案及性能进行探讨。实验通过DSC、XRD、SEM等方法对样品的性能进行表征,并测试了样品的体积密度、抗弯强度等性能。结果显示:不同的热处理条件下的锰渣微晶玻璃的主晶相均为透辉石(含铁),次晶相为普通辉石相。在800℃/0.5 h+980℃/1 h的热处理条件下得到的锰渣微晶玻璃的综合性能最优,其抗弯强度为106.82 MPa;体积密度为2.68 g/cm^3;维氏硬度为4.43 GPa;耐酸度为0.71%;耐碱度为0.07%。此外,锰渣微晶玻璃用作建筑材料,有非常大的应用潜力。     

某柴油机油底壳仿真计算分析

本文利用ABAQUS结构仿真软件对某发电用柴油机油底壳进行模态、强度计算。在发动机实际运行工况下,油底壳底部为悬空状态,模态计算结果显示油底壳一阶模态距发动机点火激励频率点较近,低于激励频率的1.2倍,模态不满足设计要求;在发动机装配过程中,油底壳底部压在装配台上,发动机在上下方向三倍的重力加速度冲击载荷工况下,油底壳产生的应力最大值低于对应材料的屈服强度极限,强度满足设计要求。通过对油底壳两种状态下的仿真分析,验证和确保了油底壳结构设计的可行性,有效避免了发动机装配和实际运行过程中故障的发生。     

偏高岭土-矿渣-磷渣地聚合物配比性能的研究

通过正交实验的方法，以地聚合物稠度、凝结时间、胶砂强度为研究依据，以偏高岭土、矿渣、磷渣、碱激发剂用量为研究对象，每个因素取3个水平，分析4个因素在各自水平上对地聚合物性能的影响。试验结果表明，偏高岭土用量是地聚合物稠度的最主要影响因素；偏高岭土和碱激发剂用量是初凝时间的主要影响因素，磷渣和偏高岭土用量是终凝时间的主要影响因素；偏高岭土用量是3 d 抗压强度的主要影响因素，矿渣用量是28 d 抗压强度的主要影响因素。按30%偏高岭土-40%矿渣-30%磷渣-10%碱激发剂制备的地聚合物具有良好的抗碳化性能，但收缩率较普通硅酸盐水泥高。     

Damage propagation and strength prediction of a single-lap interference-fit laminate structure

Frontiers of Mechanical Engineering - Experimental and finite element research was conducted on the bolted interference fit of a single-lap laminated structure to reveal the damage propagation...     

Microstructure and interface-adhesion of thermally sprayed continuous gradient elastic modulus FeCrAl-ceramic coatings

The bond strength between thermally sprayed metal bond-coats and ceramic top-coats is a key factor in determining their service life. However, most studies focus on interface modifications. In this research, based on FeCrAl bond-coats prepared by arc spraying, top-coats (Al₂O₃-40 wt% TiO₂) were prepared by plasma spraying, and heat treatment was carried out in a hypoxic atmosphere. Continuous gradient elastic modulus FeCrAl-ceramic coatings were successfully prepared, and the microstructural and mechanical properties from the substrate to the top-coats were systematically investigated. The Al₂O₃ content gradually decreased from the top-coats to the substrate, forming continuous gradient elastic modulus FeCrAl-ceramic coatings. The oxide formed during the heat treatment filled the defects in the bond-coats and greatly improved the mechanical properties of the coating. The bonding strength of the continuous gradient elastic modulus coating was 21.7% greater than that of the as-received coating.     

马来酸三乙醇胺酯对水泥水化的影响

为克服三乙醇胺早强剂对水泥抗折强度和后期强度的影响,合成了马来酸三乙醇胺酯,并通过背散射电子成像(BSE)和BET分析,研究了马来酸三乙醇胺酯对水泥水化程度、C-S-H含量和水泥水化28 d分形维数的影响。结果表明:马来酸三乙醇胺酯可促进水泥水化尤其是水泥中硅酸盐相的水化;复掺马来酸三乙醇胺酯和聚羧酸减水剂,可显著提高水泥水化产物中C-S-H的含量;三乙醇胺降低了水泥石28 d的分形维数,马来酸三乙醇胺酯单掺及与聚羧酸减水剂复掺则使水泥石28 d的分形维数提高。由此可见,马来酸三乙醇胺酯作为增强型水泥早强剂具有广阔的应用前景。     

高寒列车转向架防冰涂料的研究

在高寒地区运行的列车转向架部位容易发生结冰现象，这在一定程度上对行车安全造成隐患。对于平滑表面而言，表面的接触角滞后与冰粘附强度呈现线性关系，即接触角滞后越小，冰粘附强度越低。基于这一基础理论，本文意在构建低滞后的光滑涂层，实现涂层的低冰粘附强度，从而达到易除冰的效果。研究选用 HDI三聚体型多异氰酸酯为固化剂，对比了 3种商品化具有低表面能特性的含氟羟基树脂应用于双组分防冰涂料的性能差异，并采用疏水性最强、防冰性能最优的氟硅树脂制备了综合性能优异的高寒列车转向架防冰涂料。